No Video after Windows install starts
Posted: Thu Mar 25, 2010 11:53 pm
Just got my Fit-PC2i from Amazon today.. very excited. Had it delivered to a trade show I'm at. I wanted to run a small webserver off it at the show for registration.
I plugged it into a Samsung 22inch monitor running at 1600x1050 and when the unit booted for the first time, the bios window came up and then a starting windows display. After a few moments, the screen goes black and then the monitor light starts flashing (no signal). After 5 minutes, I turned off the unit and turned it back on. I tried to boot into Safe Mode but it said it needed to complete setup and could not do that in safe mode.
I'm assuming it doesn't like the monitor resolution for some reason. Any way I can get this running?
I plugged it into a Samsung 22inch monitor running at 1600x1050 and when the unit booted for the first time, the bios window came up and then a starting windows display. After a few moments, the screen goes black and then the monitor light starts flashing (no signal). After 5 minutes, I turned off the unit and turned it back on. I tried to boot into Safe Mode but it said it needed to complete setup and could not do that in safe mode.
I'm assuming it doesn't like the monitor resolution for some reason. Any way I can get this running?