Page 1 of 1
USB3.0 controler supports UASP ?
Posted: Fri Jan 15, 2016 5:46 pm
by belette
Hi,
I am about to buy a USB 3.0 UASP capable device (hard drive external chassis).
I would like to connect through USB 3.0 to my IPC2 but I would like to check first if the controler model in the IPC2 is supported UASP?
Please don't hesitate if you have more information and if you have the USB 3.0 model by the way.
many thanks
Re: USB3.0 controler supports UASP ?
Posted: Sun Jan 17, 2016 10:41 am
by mbirger
In the datasheets of the processor I can’t see any relevance to UASP, but to standard USB3 downstream port.
Re: USB3.0 controler supports UASP ?
Posted: Sun Jan 17, 2016 12:32 pm
by belette
thanks for your reply.
Like me I haven't see anything related to UASP.
Have you been able to figure out which exact USB3 controler model IPC2 uses?
Intel 8 Series USB 3, Intel 7 Series USB 3, Intel 7 Series USB 2, NEC/Rensas uPD720200 USB 3, NEC/Rensas uPD720201 USB 3, Intel i965 USB 2, Expresscard 54 NEC/Rensas uPD720202....?
Re: USB3.0 controler supports UASP ?
Posted: Mon Jan 18, 2016 9:14 am
by mbirger
IPC2 uses Intel Mobile Lynx Point PCH which is Intel 8 series chipset.
Re: USB3.0 controler supports UASP ?
Posted: Mon Jan 18, 2016 9:48 am
by belette
Intel 8 series is a good news, then I have chance that it would work...
I have ordered it and I will test!
many thanks
Re: USB3.0 controler supports UASP ?
Posted: Tue Jan 19, 2016 11:31 am
by mbirger
Please share if you have good news with UASP
Re: USB3.0 controler supports UASP ?
Posted: Sat Jan 23, 2016 5:09 pm
by belette
Hi,
Just to give you some news as I have received my unit and good news it is working through UAS
lsusb -v -d 152d:9561
bInterfaceProtocol 80 Bulk-Only
bInterfaceProtocol 98
lsusb -t
Bus 02.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/4p, 5000M
|__ Port 1: Dev 5, If 0, Class=Mass Storage, Driver=uas, 5000M